When I export the lightbar from Zmodeler, the v3o file is blank...

[heyjoojoo]

I finally managed to remove the lightbar from a cv model. I want to export the lightbar so that I can put it onto another car in Editor. The only problem is that the v3o file keeps coming out blank when I export it. During the deleting of the polygons to remove the car, was I supposed to do anything else to that file in Zmodeler?

[eggcarton]

When exporting, make sure you name the file the same as the surface you are you are exporting it as eg. cv_lapd

You can rename the file after.

[heyjoojoo]

When exporting, make sure you name the file the same as the surface you are you are exporting it as eg. cv_lapd

You can rename the file after.

I'll try that! Thanks

[heyjoojoo]

Hey thanks! That worked wonderfully!

[heyjoojoo]

I've had to rescale the lightbar but it's not showing up as rescaled in the Editor. I've saved the file and then exported it successfully but it's not reflecting that I rescaled it. Any insight?